Everyone knows what filling machines are used for. They are widely applied in the food industry. The production of foods like milk and beer all require filling. Frequent use of these mechanical equipment without timely maintenance and care will definitely shorten their service life. So, how should an automatic filling machine be maintained and serviced? What are the precautions? Regular maintenance

1. Timely inspection and regular maintenance: Routine inspections of pneumatic components such as cylinders, vacuum solenoid valves, speed control valves, and electrical equipment parts should be conducted every month. The routine inspection method can be checked by manual adjustment to see if it is good or bad and the operational stability. Specifically, the cylinder should be inspected to see if there is any leakage or jamming. The vacuum solenoid valve can be manually forced to operate to determine if the electromagnetic coil is burned out or the valve is blocked. For the electrical equipment part, the corresponding input and output signal lights will be used for verification. For example, the routine inspection of whether the electronic switch is damaged Check if the power distribution lines are disconnected and if all input and output components are operating normally.

2. Common precautions for daily maintenance: Check if the motor is operating normally, if the installation and usage area environment is normal, if there are any abnormalities in the refrigeration system, and if there are any abnormal vibrations or noises. Could it be that the abnormal temperature is too high, causing discoloration?

In addition, the following four points should also be noted:

1. The motor and the casing must be grounded, and the grounding wire and the neutral wire must be separated.

2. The incoming line of the switching power supply of this machine must be connected through a leakage protection switch. "Automatic

3. Pneumatic three-component standard plus pneumatic special lubricant to increase the service life of the cylinder;

4. The water pump must not operate without water. During the entire operation process, pay attention to replenishing water to the alkali storage tank and the disinfection and sterilization storage tank in a timely manner, and ensure the supply of clean water.